Description
S-W12D2
S-Series 12″ Dual 2 Ohm Subwoofer
Alpine introduces the all-new S-Series Subwoofers, their unique design substantially improves bass output and provides installation versatility. Available in a twelve, ten and eight inch each S-Series subwoofer uses a custom-stamped steel frame. These high-strength frames were designed to withstand the rigors of the improved S-Series motor. They have frame leg vents as well as a vented back plate to help cool the subwoofer voice coil and motor parts, plus a shallow design to help fit in smaller spaces.
The S-Series Subwoofers incorporate two strontium ferrite magnets that are stacked together, providing increased motor strength and excursion which ultimately delivers and accurate bass to your music. Installation time will be significantly reduced with the convenient push-type insert terminals with dual voice coil jumper system. Just strip the speaker insulation at the wire end, then insert the bare wire into the hole of the spring-loaded push terminal. While the concealed mount gasket system creates a clean, finished appearance for any vehicle.
All S-Series subwoofers are compatible with optional grilles (sold separately) to provide added protection to the cone. The grilles feature a mesh design with a S-Series logo badge.
Features
12” 2Ω+2Ω Subwoofer
High Strength Custom Steel Frame
Push-Type Insert Terminals
Dual Voice Coil Jumper System
Concealed Mount Gasket System
Strontium Ferrite Double Stacked Magnets
Optional Grilles
Specifications
Diaphram
Material: Pulp/Kevlar Cone
Design: Reinforced Parabolic Cone Structure with PP/Mica/Talc Dust Cap
Surround
Design: High Amplitude Multi-Roll (HAMR Surround)
Spider
Design: Progressive with Reinforced Layer Tinsel Leads
Voice Coil
Material: 5-Layer DVC Winding on AL Former
Design: 65mm Voice Coil with High-Temp
High-Excursion Underhung Voice Coil Configuration
Motor Structure
Pole Geometry: Airflow Optimized Dual Flare Pole Vent
Perimeter Venting with Airflow Management System
Configuration: Double-Stacked Strontium Ferrite Magnets
Frame
Material: High Strength Steel Frame
Terminals
Layout: One Side
Design: 8AWG Push Terminals with VC Configuration Jumpers
Tinsel Leads
Design: Reinforced Layer Spider Integration
Gasket
Design: Concealed Mount Gasket
Power Handling
Power Range: 600W-1800W
RMS Power Handling: 600W
Peak Power Handling: 1800W
Dimensions
Mounting Depth: 5-1/16”
General
Frequency Response: 24Hz-200Hz
Recommended Box Enclosures
Recommended Sealed Box: 0.85 cubic foot (gross volume)
Recommended Vented Box: 1.71 cubic foot (gross volume), 12.5” x 1” vent area, 16” vent length
Thiele-Small Parameters
Sensitivity (1W/1m) – SPL
DC Resistance – Re
Inductance – Le
Free Air Resonance – Fs
Equivalent Stiffness – Vas
Mechanical Q – Qms
Electrical Q – Qes
Total Q – Qts
Cone Area – Sd
Linear Excursion – Xmax (1-way)
Mechanical Travel – Xmech (P-P)